Inquiry

 

Product Selection
 
Cup Anemometer Quantity
Drop-in replacement for the discontinued P2546A-OPR. See note.
 
Services Quantity
 
Support Poles Quantity
 
Cables Quantity
Specify each custom length in the Comments box below
 
Calibrations are performed according to the Measnet procedure in our wind tunnel which is approved by Measnet and accredited according to ISO 17025. The Measnet procedure for cup anemometer calibration fulfils the requirements of IEC 61400-12-1.
 

Contact Details
 
 

Delivery Details
 
 

Comments
 
 
You haven´t selected any product: Press "To confirmation page >>" to continue anyway!
* = Input is required
This form was created at www.formdesk.com
 
Due to discontinued components we cannot offer to refurbish serial numbers below SN 4487.
Use this field to specify calibration of cup anemometers not ordered with WindSensor.
Use this field to specify post-calibration of cup anemometers not ordered with WindSensor.
Set of two Saddle Washers for OD 50 mm boom and one M10 Hex Cap Screw.
Some countries do not have national postal code systems. In that case just insert any character.
Inquiry registration will be sent to this email.
​Inquiry registration will be sent to this email as well.