Purchase Order
 

Product Selection
 
Cup Anemometer Quantity
     Drop-in replacement for the discontinued P2546A-OPR. See note.
 
Services Quantity
 
Support Poles Quantity
 
Cables Quantity
     Specify each custom length in the Comments box below
 
Calibrations are performed according to the Measnet procedure in our wind tunnel which is approved by Measnet and accredited according to ISO 17025.
The Measnet procedure for cup anemometer calibration fulfils the requirements of IEC 61400-12-1.
 

Invoice Details
 
http:// 
 

Technical Contact
 
 
All technical contact emails will receive order registration upon submission, as well as order confirmation, shipping notifications, and calibration certificates as the order is processed.
 

Delivery Details
 
 

Comments
 
 
 
 You haven´t selected any product: Press "To confirmation page >>" to continue anyway!
* = Input is required
This form was created at www.formdesk.com
 
Due to discontinued components we cannot offer to refurbish serial numbers below SN 4487.
Use this field to specify calibration of cup anemometers not ordered with WindSensor.
Use this field to specify post-calibration of cup anemometers not ordered with WindSensor.
Set of two Saddle Washers for OD 50 mm boom and one M10 Hex Cap Screw.
Some countries do not have national postal code systems. If so, enter any character.
For businesses registered in the EU only. Select Country Code and enter VAT number. Validate it here https://ec.europa.eu/taxation_customs/vies
Enter the 12 or 15 digits of the UK EORI number. Check it here https://www.gov.uk/check-eori-number.
Enter the nine-digit US Taxpayer Identification Number, identical to EIN
VAT / EORI / EIN / GST / CNPJ etc.
Some countries do not have national postal code systems. If so, enter any character.